MnCOP - Multinetwork Connection / Oper Perform

About & Features

This little script performs various commands when you connect or after you successfully gained IRC Op status.

• Supports multiple networks
• Supports QuakeNet's Q
• Execute commands on connect
• Execute commands after oper-up
• Simple INI-style configuration file
• Easy re-hashing of configuration file while XChat is running

Configuration

Place both, script and configuration, in your ~/.xchat2 (or similar) folder and edit it using your favourite text editor.
Here's the sample config that is part of the script, let's get over it step by step:

[efnet]
enable=0
connect=NICK forcenick
connect=JOIN #arandomchannel PASS
[SOMENET.net]
enable=0
connect=NS identify SOMEPASS
connect=OPER OPNICK PASS
operup=MODE %self% +v-H
operup=MODE %self% +s +cefFGkoqsSvj
operup=SETHOST look.i.got.a.fancy.ho.st 
operup=PRIVMSG SomeService :auth PASS
operup=INVITE %self% #somechannel
operup=INVITE %self% #otherchannel
operup=JOIN #somechannel,otherchannel

• [networkname]
  The name of the network the following rules should apply to.
• enable=
  Set this to '1' to enable the commands for this network.
• connect=
  This can be ANY command XChat understands.
  It'll be executed as soon as you are connected.
• postqauth=
  Same as connect=, just that it's executed after you successfully authed with QuakeNet's Q.
• connect-OPER <opnick> <pass>
  Use this to automatically oper up.
• operup=
  These are executed after you (successfully) became an IRC Op.
  Other than that, the same rules as for connect= apply.
• %self%
  This is a wildcard and will be replaced with the nick you had at the moment the script started to run.
  Can be used with both, operup= and connect= rules.

Once you have your configuration set, you can reload the configuration using the following command:

/mncop_rehash

If there have been some lines the script wasn't able to understand, it will say so.

Download

MnCOP 1.0
perform.conf Example